Problems: adhesion of foreign matter or film sticking together, maintenance is troublesome too. Solutions: select a durable static eliminator from different types (bar, spot or blower) to fit the worksite.
Problems: during analysis, surface is reflective, irregular or fractured, taking a long time for analysis. Solutions: large depth of field, free-angle observation system & real-time depth composition.
Problems: vision sensor is hard to set up, and results always vary from one person to another. Solutions: reduce setup time to 1 minute, automatic brightness and focus adjustment for stable detection.
Problems: minute uneveness on the target surface causes scanning resolution, leading to measurement errors. Solutions: use a wide spot type sensor or a displacement sensor capable of high-speed sampling.
Check out this guide to learn about these and other tricks. It contains information on the types and uses of "image enhancement filters," which are vital to perform stable inspections.
Problems: using at least 5 minutes to measure the coordinates of different measurement points one by one. Solutions: change to automatic measurement regardless of the position and orientation of your parts.
Problems: using the wrong type of marking equipment results in low quality and contrast marking. Solutions: select appropriate marking machine and fine tune pulse frequency or parameters.